Propane Gas Conversion Kits For Petrol Generators 25KW Generator Upgrade/ New
May 24, 2025 · Posted in propane · Comments Off
Prop Gas Conversion Kits For Petrol Generators 25KW Generator Upgrade/ New. Product Description: brand new high quality Made of high-quality materials for durability With this conversion kit installed, your generator will be able to use for LPG propane or CNG methane gas without any on generator’s (you can still use). This kit is only suitable for low pressure gases such as domestic propane. Conversion kits include a pressure regulator and a gas carburetor. The pressure regulator reduces the propane gas or natural gas from high to low and stabilizes the gas pressure before entering the gas carburetor and then the engine; when the generator stops working, the pressure regulator also shuts off the gas supply, So it’s safe, you don’t have to worry about the gas still going into the engine after the generator goes out. After the conversion, the generator power remains unchanged. When using propane or methane gas, power depends on generator quality and gas quality. Tris:, Low Pressure Propane for Gas/Methane CNG Gas(use only at a time) Weight: Approx. 600 grams Accessories: It is mainly designed to replace a For Honda 168F generator, but please check our gas carburetor sizes to see if it can replace your generator carburetor, if so, it will fit; if not, put Not suitable. NOTE: It is your responsibility to for ensure that the use of this conversion kit complies with your laws. NOTE: When starting with propane or methane gas, make sure there is no in the carburetor or the generator will not work properly. Instructions for use: The new does not contain oil, please add 0.9L before use. The instructions in Chinese translation below may be confusing, don’t worry, just use propane(or methane) gas as an alternative, when you use propane(or methane) gas, it’s using, just be careful, start using When using propane(methane) gas, make sure there is no in the carburetor; when using, make sure there is no propane(methane) gas in the carburetor, simple! How to start the generator: – Start with propane gas: 1. Turn off the switch(make sure there is no in the carburetor) 2. Turn on the propane gas switch. Close the throttle valve switch, pull it 3 to 4 times, open the throttle valve to the middle and then fully open it; when the engine is hot, it will open and start directly. Turn on the power switch 5. Pull the start rope 4-5 times(throttle valve closed or open to the middle)/(key) generator start 6. After starting, open the throttle switch on the carburetor mixing device 7. The generator starts normally Generator shutdown steps: Turn off the propane gas tank switch first, then turn off the generator switch. Start with : 1. Turn off the propane gas 2. Turn off the choke switch on the carburetor 4. Pull the starting rope several times, the generator starts 6. The generator starts normally Notice: 1. Do not use indoors, if necessary, please for ensure good ventilation 2. Do not use when the intake pressure is too high or too low, the working pressure should be between 2.84.8 3. It cannot be determined whether there is air leakage at the outlet connection of the gas tank or the gas connection of the pipeline 4. Do not turn the gas storage tank upside down to prevent gas impurities from entering the gas Package Included: 1 Generator Conversion Kit Note: 1. The real color of the item may be slightly different from the pictures shown on website caused by many factors such as brightness of your monitor and light brightness. Please allow slight manual measurement deviation for the data. Please kindly note that. Also, the each additional item means. The the same color and size. For TRANSIT time may be a little delayed because of the. Positive is very important to us. If you have any questions.
